CHECK AND TEST 1
Step 1
Open left fridge door to see if gasket plate turns up and down automatically.
DIAGNOSIS 1
CHECK AND TEST 2
Step 1
To assess whether rework was successful, place a torch on shelf with light pointed towards the gasket.
Step 2
Close the door to see if any light is visible from interior.
DIAGNOSIS 2
CHECK AND TEST 3
Step 1
Blow hot air on gasket with a hair dryer to soften gasket, so it can be easily attached to cabinet.
Step 2
Place a torch on shelf
with light pointed
towards the gasket.
Step 3
Close the door again to see if any light is visible from interior.
Step 4
If light still leaks out from interior, place the front edge of a steel ruler parallel to the gasket plate. Then, measure the gap between the ruler and the plate.
DIAGNOSIS 3
PROCEDURE 1
Step 1
Remove the screw cover in the middle.
Step 2
Loosen 2 screws
of terminal cover in
anticlockwise direction.
Step 3
Disconnect the terminal.
Step 4
Use 2 hands to move gasket plate up.
Step 5
Lift gasket plate up until negative end is released from positive end of fastener.
PROCEDURE 2
Tip 1
Connect the terminals then place wires carefully so they will not be crushed by cover.
Tip 2
Check to make sure gasket plate can turn properly up and flat when doors are opened and closed.
Step 1
Blow hot air on gasket with a hair dryer to soften gasket, so it can be easily attached to cabinet.
Step 2
To assess whether rework was successful, place a torch on shelf and point light towards gasket.
Step 3
Close door to see if there is any light leaking out.
DIAGNOSIS 2
GO BACK TO COMPONENT LIST