CHECK AND TEST 1
Step 1
Place torch in the cabinet and check to see if any light leaks out through gasket.
Step 2
Use hair dryer to blow hot air and soften gasket so it is easier to attach to cabinet.
DIAGNOSIS 2
PROCEDURE 1
Note
When hinge adjustment is required, please start by disassembling hinge and fridge door.
Step 1
Unscrew hinge cover.
Step 2
Remove the cover.
Step 3
Disconnect the terminals.
Step 4
Unscrew 3 bolts and remove the top hinge.
Step 5
Remove fridge door.
Step 6
Unscrew 3 bolts and remove the middle hinge.
Step 7
Take away bottom door.
Step 8
Tilt cabinet 10 degrees.
Step 9
Unscrew the adjustable foot.
Step 10
Unscrew 4 bolts and remove bottom hinge.
CHECK AND TEST 2
Case 1
Light leaks out from the corner of opening side.
Note
Step 1
Add washer to make middle hinge move outward.
Step 2
Use hinge with big hole and push it out.
Step 3
Use hair dryer to blow hot air onto gasket to soften it so that gasket can be attached onto cabinet more easily.
Case 2
Light is coming out from near the corner on the hinge side.
Step 1
Remove washer to make middle hinge move inward.
Step 2
Push top hinge in.
Step 3
Use hair dryer to blow hot air onto gasket to soften it so that gasket can be attached onto cabinet more easily.
DIAGNOSIS 2
CHECK AND TEST 3
Case 3:
Light leaks in the middle of hinge or opening side.
Step 1
Use steel ruler to measure the deformation of door and cabinet.
Step 2
Use steel ruler to measure the deformation of door and cabinet.
DIAGNOSIS 3
PROCEDURE 3
Tip 1
Don’t forget to add washer onto hinge pin.
Tip 2
When installing door on hinge, please make sure door-stopper and hinge are properly aligned.
Tip 3
Make sure gasket is attached properly.
Tip 4
Make sure gaps between doors are even.
Tip 5
Check to make sure gasket plate turns over properly when door is opened and closed.
GO BACK TO COMPONENT LIST