Step 1

Remove all drawers.

Step 2

Remove all shelves.

Step 3

Remove the vertical partition plate:
a. Insert 2mm slotted screwdriver into the gap;
b. Lever up the cover plate from bottom;

c. Insert 2mm slotted screwdriver into the side gap;
d. Lever up the cover plate from bottom;

e. Pull the bottom end of cover out;
f. Pull the top of the cover out;

g. Take pipes out and pull them into a horizontal position;
h. Push the latch down and lift top out of the cavity;

i. Push the latch up and pull bottom out of the cavity;
j. Pull the partition outward and remove partition;

k. View of interior once partition has been removed.

Step 4

Dismantle the air duct.
a. Hold the bottom of air duct;
b. Pull air duct out from below;

c. Disconnect the terminal for fan motor;
d. Disconnect the terminal of freezer temp. sensor;

e. Remove air duct.

Step 1

Check to see whether fan blade is broken.

Step 2

Supply DC 12V power to fan to check if there is any clash.

Step 3

Shake fan blade to check if fan is loose or not.

Note

Tip 1

When installing the air duct, make sure to move wires out of the way to prevent crushing by air duct.

Tip 2

After pushing the air duct into position, you should hear a click sound. If not, repeat again.

Tip 3

Check to see if there is a wide gap between air duct and cabinet.
IF SO, install air duct again.

Tip 4

Check to make sure latches are inserted into cavities properly.

Tip 5

First, insert top of cover plate into the gap, then bend plate to insert bottom end. Lastly, push middle into slot.