CHECK AND TEST 1
Step 1
Open one fridge door to verify functioning of LED light.
Step 2
Open fridge door and freezer door on same side to same degree for 5 seconds.
DIAGNOSIS 1
Note
Please make sure magnetic switches in both sides are checked.
PROCEDURE 1
Step 1
Use 2mm slotted screwdriver to lever the cover off.
Step 2
Move the cover away from the buckle.
Step 3
Disconnect the terminal and take out the switch.
CHECK AND TEST 2
Step 1
Check to see if the terminal is connected well or not.
Step 2
Attach magnetic bar to magnetic switch.
Step 3
Use multimeter to test the resistance value.
Step 4
Take note of the value.
DIAGNOSIS 2
Note
Result 0 depends
on measure range
of multimeter.
Recommended measure
range setting is at least
2k ohms.
PROCEDURE 2
Step 1
Carefully place switch in trough to avoid damage.
Step 2
Insert the pin into buckle.
Step 3
Push the cover in.
CHECK AND TEST 3
Step 1
Open one fridge door to verify functioning of LED light.
Step 2
Open fridge door and freezer door on same side to same degree for 5 seconds.
DIAGNOSIS 3
Note
Please make sure magnetic switches in both sides are checked.
CHECK AND TEST 4
Put a small bolt on edge of magnetic area.
DIAGNOSIS 4
Note
Please make sure to test
2 magnetic bars:
one on left side, the
other on right side.
PROCEDURE 3
Step 1
Unscrew hinge cover.
Step 2
Remove the cover.
Step 3
Disconnect the terminals.
Step 4
Unscrew 3 bolts and remove the top hinge.
Step 5
Remove fridge door.
Step 6
Loosen the middle hinge and remove it.
Step 7
Remove freezer door and replace with new one.
PROCEDURE 4
Tip 1
Don’t forget to add washer onto hinge pin.
Tip 2
When installing door
on the hinge, please
check to ensure proper
alignment of
door-stopper and hinge.
Tip 3
Ensure gasket is attached properly.
Tip 4
Gaps between door must be even and equal.
Tip 5
Make sure the gasket plate rotates properly when door is opened or closed.
CHECK AND TEST 5
Step 1
Open one fridge door to verify functioning of LED light.
Step 2
Open fridge door and freezer door on same side to same degree for 5 seconds.
DIAGNOSIS 5
Note
Please make sure magnetic switches in both sides are checked.
