8.5 RELIABILITY FAULTS:

DOOR STOPPER IS BROKEN

CHECK AND TEST 1

Step 1

Push the door to an angle of 8° from cabinet, if the door doesn’t close automatically, there is a problem with the door stopper.

Step 2

Check the alignment between door stopper and hinge to find out root causes.

Step 3

Check to see whether screw is screwed correctly into final position. If not,

this would cause misalignment between door stopper and hinge.

Step 4

Check if there are too many washers, causing misalignment between door stopper and hinge.

Step 5

Check if the door stopper is deformed and causing misalignment.

DIAGNOSIS 1


PROCEDURE 1


Step 1

Unscrew hinge cover.

Step 2

Remove the cover.

Step 3

Disconnect the terminals.

 

Step 4

Unscrew bolts and remove the top hinge.

Step 5

Remove upper door.

Step 6

Unscrew 3 bolts and remove the middle hinge.

Step 7

Remove lower door.

Step 8

Tilt cabinet.

Step 9

Unscrew the adjustable foot.

 

Step 10

Unscrew the adjustable foot.

Reverse procedures above to install the door, please pay attention to the key points below.

Tip 1

Don’t forget to add washer onto hinge pin.

Tip 2

When installing door onto hinge, please check the match between door- stopper and hinge.

Tip 3

Make sure gasket is attached well.

Tip 4

Make sure gaps between doors are even.

GO BACK TO FAULT LIST RELIABILITY