CHECK AND TEST 1

NOTE

Step 1

Open the door to let internal temperature warm up to ambient temperature, then set gear to the coldest setting and let appliance run for 40 min.

Step 2

Turn knob slowly to lowest gear until the compressor stops.

DIAGNOSIS 1

PROCEDURE 1

Step 1

Unscrew LED cover.

Step 2

Remove LED cover.

Step 3

Unscrew thermostat cover.

Step 4

Lever off the buckle and push the thermostat out.

Step 5

Disconnect terminal for LED.

Step 6

Disconnect terminal for thermostat.

CHECK AND TEST 2

Step 1

Test thermostat individually when set to Gear 0.

DIAGNOSIS 2

PROCEDURE 2

Step 1

Pull capillary from the hole to replace the thermostat.

Tips 1:

When inserting capillary into the hole, make sure the first red mark goes in the hole, but second one remains outside of the hole.


Tips 2:

When inserting thermostat into the buckle, please push the control knob into the buckle first.

Tips 3:

Make sure wires are twisted around screw pole to avoid damaging wires with screw. After replacing thermostat, do a test performance.

DIAGNOSIS 3

CHECK AND TEST 1

NOTE

Step 1

Open the door to let internal temperature warm up to ambient temperature. Then, set gear to the coldest setting and let appliance run for 40 min.

Step 2

Turn knob slowly towards lower settings until the compressor stops.

DIAGNOSIS 1

PROCEDURE 1

Step 1

Remove screw cover.

Step 2

Unscrew the screw.

Step 3

Remove thermostat cover.

Step 4

Disconnect the terminals.

Step 5

Lever off the knob.

Step 6

Disconnect terminal for thermostat.

Step 7

Test thermostat individually when Gear is set to 0.

DIAGNOSIS 2

PROCEDURE 2

Step 1

Pull capillary from the hole to replace a new thermostat.

Tips 1:

When inserting capillary into the hole, make sure the first red mark goes into the hole, but second one remains outside of the hole.

Tips 2:

Make sure the pins of thermostat cover are properly inserted into the holes.

Tips 3:

Make sure wires are placed into cavity of thermostat.

DIAGNOSIS 2

GO BACK TO COMPONENT LIST