CHECK AND TEST 1

Step 1

Use steel ruler to measure the gap and misalignment. 

Case 1

Vertical gap is not even.

DIAGNOSIS 1

PROCEDURE 1

Step 1

Polish Unscrew hinge cover.

Step 2

Remove the cover.

Step 3

Unscrew 3 bolts and remove the top hinge.

Step 4

Remove upper door.

Step 5

Unscrew 2 bolts and remove the middle hinge.

Step 6

Remove bottom door.

Step 7

Tilt cabinet by 10 degrees.

Step 8

Unscrew the adjustable foot.

Step 9

Unscrew 2 bolts and remove bottom hinge.

PROCEDURE 2

Step 1

Add washer to middle hinge or move top and bottom hinge inward or outward.

Step 2

Move the top or bottom hinge inward or outward.

PROCEDURE 3

Step 1

After installing the door, blow hot air onto gasket with Hair Dryer to soften, so that gasket can be easily attached onto cabinet.

Tip 1

Don’t forget to add a washer onto hinge pin. 

Tip 2

When installing door onto hinge, please check the alignment of doorstopper and hinge.

Tip 3

Make sure gasket is properly attached.

Tip 4

Make sure gaps between doors are even.

DIAGNOSIS 2

Case 2

Door and side panel is misaligned.

DIAGNOSIS 1

PROCEDURE 1

Step 1

Unscrew hinge cover. 

Step 2

Remove the cover.

Step 3

Unscrew 3 bolts and remove the top hinge. 

Step 4

Remove upper door.

Step 5

Unscrew 2 bolts and remove the middle hinge. 

Step 6

Remove bottom door.

Step 7

Tilt cabinet by 10 degrees.

Step 8

Unscrew the adjustable foot.

Step 9

Unscrew 2 bolts and remove bottom hinge.

PROCEDURE 2

Step 1

Move the middle hinge to left or right.

Step 2

Move the top or bottom hinge to left or right.

PROCEDURE 3

Step 1

After installing the door, blow hot air onto gasket with Hair Dryer to soften, so that gasket can be easily attached onto cabinet.

Tip 1

Don’t forget to add a washer onto hinge pin.

Tip 2

When installing door onto hinge, please check the alignment of doorstopper and hinge.

Tip 3

Make sure gasket is properly attached.

Tip 4

Make sure gaps between doors are even.

DIAGNOSIS 2

Case 3

Horizontal gap is not even or door and top cabinet is misaligned.

DIAGNOSIS 1

PROCEDURE 1

Step 1

Add or reduce washers to adjust misalignment in fore-and-aft direction.

DIAGNOSIS 2

CHECK AND TEST 2

Step 1

Check if hinge sleeve is worn.

DIAGNOSIS 3

PROCEDURE 2

Step 1

Unscrew hinge cover.

Step 2

Remove the cover.

Step 3

Unscrew 3 bolts and remove the top hinge.

Step 4

Remove upper door.

Step 5

Unscrew 2 bolts and remove the middle hinge.

Step 6

Remove bottom door.

Step 7

Tilt cabinet by 10 degrees.

Step 8

Unscrew the adjustable foot.

Step 9

Unscrew 2 bolts and remove bottom hinge.

PROCEDURE 3

Step 1

After installing the door, blow hot air onto gasket with Hair Dryer to soften, so that gasket can be easily attached onto cabinet.

Tip 1

Don’t forget to add a washer onto hinge pin.

Tip 2

When installing door onto hinge, please check the alignment of doorstopper and hinge.

Tip 3

Make sure gasket is properly attached.

DIAGNOSIS 4

GO BACK TO FAULT LIST REALIBILITY