CHECK AND TEST 1


Step 1

Unscrew the screws on the rear light wire connector cover.

Step 2

Prize up to remove the light wire connector cover.

Step 3

Check if the connector is ok.

DIAGNOSIS 1


CHECK AND TEST 2

Step 1

Disconnect the wire connector.

Step 2

Measure the voltage of the therminals from cabinet side.

DIAGNOSIS 2

PROCEDURE 1


Step 1

Prize up the top side of lower hinge cover.

Step 2

Remove the hinge cover.

Step 3

Prize up the upper hinge cover with a screwdriver.

Step 4

Unscrew upper hinge part.

Step 5

Remove the door.

Tip 1

Make sure gasket is properly attached.

Tip 2

Make sure the door is parallel to the cabinet.

Step 6

Connect the door light wire.

Step 7

Install the cover of door light wire.


CHECK AND TEST 3


Step 1

Power on the appliance and open door to check if the light turns on or not.

DIAGNOSIS 3

GO BACK TO COMPONENT LIST