Unscrew 3 bolts and
remove door hinge.

Lay down the cabinet and unscrew the adjustable foot.

Case 1:
Light leaks from the
corner on opening side.

Unscrew the bottom hinge and move it outward.

Use hinge with large hole
and push outward.

Use hair dryer to blow hot air onto gasket to soften so that gasket can be easily attached onto cabinet.

Case 2:
Light leakage can be seen from the corner of
door hinge side.

Unscrew the bottom hinge and move it inward.

Use hinge with large hole and push inward.

Use hair dryer to blow hot air onto gasket to soften so that gasket can be easily attached onto cabinet.

After adjusting hinges, put a torch into cabinet and check to see if any light leaks out through gasket.

Case 3:
Light leakage can be seen from the middle.

Use steel ruler to measure the deformation of cabinet.

Use steel ruler to measure the deformation of door.

Push the top cover forward.

Unscrew 3 bolts and remove door hinge.

Use steel ruler to measure the deformation
of door to make sure new door is good before
installation.

Use hair dryer to blow hot air onto gasket to
soften so that gasket can be easily attached onto cabinet.

Don’t forget to add washer onto hinge pin
(if there is one).

When installing door onto hinge, please check
the alignment between door-stopper and hinge.

Make sure gasket is properly attached.

Make sure the door is parallel to the cabinet.

Place a torch in cabinet and check to see if light leaks out from gasket.