CHECK AND TEST 1

Step 1

Open the door to let internal temp. warm up to ambient temp.. Then, set gear to the coldest setting and let appliance run for 40 min.

Step 2

Turn knob slowly towards lower settings until the compressor stops.

DIAGNOSIS 1



PROCEDURE 1

Step 1

Remove screw cover on the LED.

Step 2

Unscrew LED cover.

Step 3

Remove thermostat cover.

Step 4

Pull capillary from the hole

Step 5

Disconnect the terminals.

Step 6

Lever off the knob.

Step 7

Disconnect terminal for thermostat.

CHECK AND TEST 2

Step 1

Test thermostat individually when Gear is set to 0.

DIAGNOSIS 2

PROCEDURE 2

Tip 1:

When inserting capillary into the hole, make sure the first red mark goes into the hole, but second one remains outside of the hole.

Tip 2:

Make sure the pins of thermostat cover are properly inserted into the holes.

Tip 3:

Make sure wires are placed into cavity of thermostat.

CHECK AND TEST 3

Step 1

Set gear to the coldest setting.

Step 2

Close the doors and let appliance run for 40 min.

DIAGNOSIS 3