CHECK AND TEST 1
Step 1
Place a torch in cabinet and check to see if light leaks out from gasket.
Step 2
Blow hot air onto gasket with hair dryer to soften, so that gasket can be easily attached onto cabinet.
DIAGNOSIS 1
PROCEDURE 1
Step 1
Remove the screw cover.
Step 2
Unscrew.
Step 3
Remove top cover.
Step 4
Unscrew 3 bolts and remove the door hinge.
Step 5
Remove upper door.
CHECK AND TEST 2
Case 1:
Light leaks from the corner on opening side.
Step 1
Add washer to make middle hinge move outward.
Step 2
Use hinge with large hole and push outward.
Step 3
Use hair dryer to blow hot air onto gasket on hinge side to soften so that gasket can easily attach onto cabinet.
Step 4
Place a torch in cabinet and check to see if light leaks out from gasket.
DIAGNOSIS 2
CHECK AND TEST 3
Case 2:
Light leaks at hinge side.
Step 1
Remove washer to make middle hinge move inward.
Step 2
Use hinge with large hole and push inward.
Step 3
Use hair dryer to blow hot air onto gasket on hinge side to soften so that gasket can easily attach onto cabinet.
Step 4
Place a torch in cabinet and check to see if light leaks out from gasket.
DIAGNOSIS 2
CHECK AND TEST 4
Case 3:
Light leakage can be seen from the middle.
Step 3
Use steel ruler to measure the deformation of cabinet.
Step 4
Use steel ruler to measure the deformation of door.
DIAGNOSIS 4
PROCEDURE 2
Step 1
Use steel ruler to measure the deformation of door to make sure new door is good before installation.
Step 2
Fix upper door onto middle hinge.
Step 3
Screw 3 bolts and fix top door hinge.
Step 4
Fix top cover.
Step 5
Fix top cover screw.
Step 6
Fix screw cover.
PROCEDURE 3
Tip 1
Don’t forget to add washer onto hinge pin.
Tip 2
When installing door onto hinge, please check the alignment of door stopper and hinge.
Note: picture shown is not the right one, but just an example.
Tip 3
Make sure gasket is properly attached.
Tip 4
Make sure gaps between doors are even.
CHECK AND TEST 5
Step 1
Place a torch in cabinet and check to see if light leaks out from gasket.
DIAGNOSIS 5
