CHECK AND TEST 1

Check to make sure water tank is pushed into proper final position.
If not, push it into place.

Check to see if water stops dripping and expels normally.
If not, follow procedures to do more check.

Remove tank.

Verify whether valve is screwed properly into final position.

Check to see if the slot on door for water tank is deformed.

Check to see if the slot on water tank is deformed.

Check to see if the rubber washer is broken.

Loosen the latch.

Remove the cover.

Lever off the other washer.

Remove the washer and check if it is broken.

Check the attachment of rubber core.

Pull the bottom part of valve.

Disassemble it.

Check to see if the rubber is cracked or deformed.

Measure the free length of spring.

Pull out the tap.

Check if white plastic is broken or deformed.

PROCEDURE 1

Remove the screw cover.

Unscrew.

Remove top cover.

Unscrew 3 bolts and remove the door hinge.

Remove upper door.

Unscrew 2 bolts and remove the middle hinge.

Remove bottom door.

PROCEDURE 2

Don’t forget to add a washer onto hinge pin.

When installing door onto hinge, please check the alignment of doorstopper and hinge.

Make sure gasket is properly attached.

Make sure gaps between doors are even.