Note


PROCEDURE 1


Step 1

a. Lever off the cover with
2mm slotted driver.
b. Unscrew with 6mm
cross-head screwdriver.
c. Disconnect the terminal
and remove LED.
d. Reverse above steps to
install LED.

REVERSE STEPS ABOVE
TO INSTALL LED.

Note

Put wires into buckle
to avoid damaging with
screw when installing
LED.

PROCEDURE 2


Step 1

a. Hold the cover and turn it
in anti-clockwise direction
to loosen the cover, later
move it away.
b. Unfasten the clip.
c. Remove LED light.
d. Disconnect the
terminal.

REVERSE STEPS ABOVE
TO INSTALL LED.

Note

When installing LED,
please make sure glass
pearl does not touch
the hands or any stiff
material.

CHECK AND TEST 1

Step 1

Provide upper LED with
DC12V to check whether
it turns on or not.

Step 2

Provide LED in back with
DC12V to check whether
it turns on or not.

DIAGNOSIS 1


CHECK AND TEST 2

Step 1

Check to see if terminal A,
B, C are filled by foam.

Step 2

Use tweezers to remove
the foam clearly.

DIAGNOSIS 2


CHECK AND TEST 3

Step 1

Check to make sure wire
order is correct.

Step 2

Check if wire order for LED
on the back is correct.

Step 3

Check to make sure there
is a good connection.

DIAGNOSIS 3


PROCEDURE 2


Step 1

Cut off the wire.

Step 2

Peel off the sleeves.

Step 3

Ensure proper wire order and connect.

Step 4

soldering

Step 5

Cover connecting point with electrical tape.

CHECK AND TEST 4

Step 1

After reworking, open one fridge door to see if LED is on or not.

DIAGNOSIS 2


GO BACK TO CHOOSE YOUR MANUAL