CHECK AND TEST 1
Place a torch in cabinet and check to see if light
leaks out from gasket.

Case 1:
Light leaks from the corner on opening side.

Step 1

Blow hot air onto gasket with hair dryer to soften, so that gasket can be easily attached onto cabinet.

DIAGNOSIS 1

PROCEDURE 1

Step 1

Unscrew hinge cover.

Step 2

Remove the cover.

Step 3

Instructions for adjusting hinge.

Step 4

Remove upper door.

Reverse steps above to reinstall or replace
hinges and doors.

PROCEDURE 2

Step 1

Add washer to make middle hinge move
outward.

Step 2

Use hinge with large hole and push outward.

Step 3

Use hair dryer to blow hot air onto gasket on
hinge side to soften so that gasket can easily
attach onto cabinet.

DIAGNOSIS 2
CHECK AND TEST 2
Place a torch in cabinet and check to see if light
leaks out from gasket.

Case 1:
Light leaks from the corner on hinge side.

Step 1

Use hair dryer to blow hot air onto gasket to
soften so that gasket can be easily attached onto cabinet.

DIAGNOSIS 3

PROCEDURE 3

Step 1

Unscrew hinge cover.

Step 2

Remove the cover.

Step 3

Instructions for adjusting hinge.

Step 4

Remove upper door.

Reverse steps above to reinstall or replace
hinges and doors.

PROCEDURE 4

Step 2

Use hinge with large hole and push outward.

Step 3

Use hair dryer to blow hot air onto gasket on
hinge side to soften so that gasket can easily
attach onto cabinet.

DIAGNOSIS 4
CHECK AND TEST 3
Place a torch in cabinet and check to see if light
leaks out from gasket.

Case 3:
Light leaks from the middle.

Step 1

Remove washer to make middle hinge move
inward.

Step 2

Use hair dryer to blow hot air onto gasket to
soften so that gasket can be easily attached onto cabinet.

Step 3

Use steel ruler to measure the deformation
of cabinet.

Step 4

Use steel ruler to measure the deformation
of door.

DIAGNOSIS 5

PROCEDURE 5

Step 1

Unscrew hinge cover.

Step 2

Remove the cover.

Step 3

Instructions for adjustinghinge.

Step 4

Remove upper door.

Reverse steps above to reinstall or replace
hinges and doors.

PROCEDURE 6

Step 1

Don’t forget to add washer onto hinge pin.

Step 2

When installing door onto hinge, please
check the alignment of doorstopper and hinge.

Step 3

Make sure gasket is properly attached.

Step 4

Make sure gaps between doors are even.

CHECK AND TEST 4

Step 1

Place a torch in cabinet and check to see if light
leaks out from gasket.

DIAGNOSIS 6
PROCEDURE 7


Tip 1

Don’t forget to add washer onto hinge pin.

Tip 2

When installing door onto hinge, please
check the alignment of doorstopper and hinge.

Tip 3

Make sure gasket is properly attached.

Tip 4

Make sure gaps between doors are even.

GO BACK TO CHOOSE YOUR MANUAL