CHECK AND TEST 1
Step 1
Unscrew.
Step 2
Remove the mainboard cover.
Step 3
Check if terminal is pushed into final position.
Step 4
Check to see if terminal is full of foam.
If so, use tweezers to remove foam.
Step 5
Use multimeter to measure resistance value.
Step 6
Record the value.
Step 7
Test temperature on air duct close to sensor.
Use tested temperature to find out the reference resistance in following chart.
DIAGNOSIS 1
PROCEDURE 1
Step 1
Pull out the drawers.
Step 2
Take out the shelves.
Step 3
Unscrew the 4 screws.
Step 4
Hold the bottom of air duct and pull it out.
Step 5
Disconnect the terminal of fan motor.
Step 6
Remove air duct.
CHECK AND TEST 2
Step 1
Check to see if sensor is in right position.
DIAGNOSIS 2
CHECK AND TEST 3
Step 1
Check to ensure if sensor wires have been
cut off.
DIAGNOSIS 3
PROCEDURE 2
Step 1
Cut wire off from broken area.
Step 2
Peel off the sleeves.
Step 3
Check to ensure proper wire order and connect
them.
Step 4
Tin soldering.
Cover connection with electrical tape.
CHECK AND TEST 4
Step 1
Test resistance of sensor.
Step 2
Read the value.
Step 3
Measure the temperature of sensor.
CHECK AND TEST 5
Step 1
Connect the 2 ends in PCB ends.
Step 2
Test connection.
DIAGNOSIS 5
PROCEDURE 3
Tip 1
Before installing the air duct, please tie all wires
together.
Tip 2
fan well.
Tip 3
Insert left side first, then other side. Make sure
the cavity on the side is aligned with the ribs on
inner liner.
Tip 4
Check to see if there is a wide gap between air
duct and cabinet. If so, install air duct again.
GO BACK TO COMPONENT LIST