CHECK AND TEST 1
Step 1
Place a torch on shelf and point light towards gasket.
Step 2
Close freezer door to check if there is any light leaking out.
Step 3
Blow hot air to gasket by hair dryer to soften gasket so that gasket can be attached onto cabinet easily.
DIAGNOSIS 1
PROCEDURE 1
Step 1
Unscrew hinge cover.
Step 2
Remove the cover.
Step 3
Disconnect the terminals.
Step 4
Unscrew 3 bolts and remove the top hinge.
Step 5
Remove upper door.
PROCEDURE 2
Case 1:
Light leaks out from the corner of opening side.
Step 1
Unscrew the adjustable foot.
Step 2
Unscrew 4 bolts and remove bottom hinge.
Step 3
Use hinge with large hole and push outwards.
Step 4
Install freezer door.
Case 2:
Light leaks out from the corner of hinge side.
Step 1
Unscrew the adjustable foot.
Step 2
Unscrew 4 bolts and remove bottom hinge.
Step 3
Use hinge with large hole and push inwards.
Step 4
Install the door.
Case 3:
Light leaks out from the middle of opening side or hinge side.
Step 1
Use steel ruler to measure the deformation of fridge door.
If deformation is more than 3mm, replace the fridge door.
Step 2
Use steel ruler to measure the deformation of cabinet.
If deformation is more than 3mm, replace the appliance.
NOTE
Tip 1
Make sure gasket is attached well.
CHECK AND TEST 2
Step 1
Place a torch on shelf and point light towards gasket.
Step 2
Close freezer door to see if there is any light leaking out.
DIAGNOSIS 2
GO BACK TO COMPONENT LIST