CHECK AND TEST 1

Step 1

Open fridge doors and check carefully to see whether gasket is cracked. 

Step 2

Check carefully if gasket is deformed. 

DIAGNOSIS 1


PROCEDURE 1


Step 1

Pull gasket out by the corner. 

Step 2                                   

Install a new gasket, starting from the corner. 
Make sure base of gasket is pressed into trough completely 



Step 3

Make sure gasket is properly aligned with
edges of trough.

Step 4

Close the door, make sure gasket is well
attached.

CHECK AND TEST 2

Step 1

To assess whether rework was successful,

place a torch on shelf and point light towards
gasket.

Step 2

Close door to see if there

is any light leaking out.

DIAGNOSIS 2


CHECK AND TEST 3

Step 1

Check if gasket is wrinkling or not.

CHECK AND TEST 4

Step 1                                      Measure width of gasket
seat opening with vernier
calipers.


Step 2

If entrance of gasket
seat is wider than 6 mm,
replace old gasket with
new one with 6.5mm
base.
Use tool of same shape
as gasket seat and insert
it into gasket seat, then
flip the tool around.

DIAGNOSIS 4


PROCEDURE 2


Step 1

Before installing the
new door, first check
the seal of the gasket.
Check to see if gasket is
detaching.

DIAGNOSIS 5 


Step 2

Insert the gasket into
gasket seat, and pull it
with a force of 30Nm.

Step 1

Unscrew hinge cover.

Step 2

Remove the cover.

Step 3

Disconnect the terminals.

Step 4

Unscrew 3 bolts and
remove the top hinge.

Step 5

Remove the door.

PROCEDURE 3


Tip 1

Make sure gasket of
the new door is not
detaching.

Tip 2

Insert the gasket into
gasket seat and pull it
with a force of 30N.

Tip 3

After installing, make
sure gap between fridge
door and freezer door is
even.

CHECK AND TEST 5

Step 2

To assess whether
rework was successful,
place a torch on shelf
and point light towards
gasket.

Step 2

Close door to see if there
is any light leaking out.

DIAGNOSIS 6


GO BACK TO COMPONENT LIST