CHECK AND TEST 1

Step 1

Unscrew cover of
mainboard with a
cross-head screwdriver.

Step 2

Check if terminal in PCB
area is inserted to final
position.
If not, reinsert it to final
position.

Step 3

Unscrew hinge cover.

Step 4

Check if terminal in hinge
cover is inserted to final
position.
If not, reinsert it to final
position.


DIAGNOSIS 1

CHECK AND TEST 2

Step 1

Check if wire orders in
PCB area and hinge
cover area are correct or
not.
Right picture shows the
correct wire order.

DIAGNOSIS 2


PROCEDURE 1


Step 1

Cut off the wire.

Step 2

Peel off the sleeves.

Step 3

Make sure wires are
in proper order and
connect them. 

Step 4

Tin soldering.


Step 5

Cover connecting point
with electrical tape.

PROCEDURE 2



CASE 1:
METAL DOOR




Step 1

Push a 6mm sucker
onto display and turn
the knob to strengthen
suction force.

Step 2

Attach strap to knob
to facilitate pulling out
display board.




CASE 2:
GLASS DOOR




Step 1

Lever off the cover on
door cap.

Step 2

Remove the screws (in
total 2).

Step 3

Pull out the plastic;

Step 4

Disconnect the terminal
for display panel.



CHECK AND TEST 3

Step 1

Check if connection and
wire order in display area
are correct or not.



DIAGNOSIS 3


CHECK AND TEST 4


Step 1
Set multimeter to
resistance gear.

Step 2
Check wire connection
from PCB area to hinge
cover area.

Step 3

Check wire connection
from hinge cover area to
display area.

DIAGNOSIS 4


PROCEDURE 3


Step 1

Unscrew hinge cover.

Step 2

Remove the cover.

Step 3

Disconnect the terminals.

Step 4

Unscrew 3 bolts and
remove the top hinge.

Step 5

Remove the door.

PROCEDURE 4


Tip 1

Make sure gasket is
attached well.

Tip 2

Make sure gap between
fridge door and freezer
door is even.

CHECK AND TEST 5


CHECK AND TEST 6


PROCEDURE 5


Step 1

Unscrew cover of
mainboard with a
Cross-head screwdriver.

Step 2

Disconnect terminals.

Step 3

Unscrew the mainboard. 

Step 4

Prize off the buckle. 

Step 5

Remove mainboard. 


PROCEDURE 6


CHECK AND TEST 7