CHECK AND TEST 1

Step 1

Plug off the product and open the door to let internal temp., warm up to ambient temperature. 

Step 2

Set thermostat to max-1, and plug in to switch on the appliance.

DIAGNOSIS 1

CHECK AND TEST 2

Step 1

After first stop, please consult table 1 to find bulb position, then measure temperature in the area near thermostat bulb. 

DIAGNOSIS 2


PROCEDURE 1

Step 1

Lever off screw cover. 

Step 2

Unscrew. 

Step 3

Remove thermostat cover

Step 4

Pull capillary from the hole

Step 5

Pull capillary from the hole

Step 6

Disconnect terminal for LED. 

Step 7

Disconnect terminal for thermostat.

Step 8

Lever off the knob 

 

Step 9

Unscrew the nut. 

PROCEDURE 2

Tip 1:

When inserting capillary into the hole, make sure the first red mark goes in the hole, but second one remains outside of the hole. 

Tip 2:

Make sure the pins of thermostat cover are inserted into the holes.

Tip 3:

Make sure wires are placed into cavity of thermostat. 

CHECK AND TEST 3

Step 1

After first stop, please consult table 1 to find bulb position, then measure temperature in the area near thermostat bulb.

Step 2

Set the knob of thermostat at gear max-1, and plug in to switch on the appliance.

DIAGNOSIS 3

DIAGNOSIS 4

GO BACK TO COMPONENT LIST