CHECK AND TEST 1

Step 1

Open the door to let internal temperature warm up to ambient temperature, then set gear to the coldest setting and let appliance run for 40 min.

Step 2

Turn knob slowly to lowest gear until the compressor stops.

DIAGNOSIS 1

PROCEDURE 1

Step 1

Lever off screw cover.

Step 2

Remove screw cover

Step 3

Remove thermostat cover.

Step 4

Disconnect terminals. 

Step 5

Lever off the knob.

Step 6

Disconnect terminal for thermostat. 

Step 7

Test thermostat individually when Gear is set to 0.

DIAGNOSIS 2

PROCEDURE 2

Step 1

Pull capillary from the hole to replace the thermostat.

Tips 1

When inserting capillary into the hole, make sure the first red mark goes in the hole, but second one remains outside of the hole.

Tips 2

Make sure the pins of thermostat cover are properly inserted into the holes.

Tips 3

Make sure wires are placed into cavity of thermostat.

DIAGNOSIS 3


GO BACK TO COMPONENT LIST