CHECK AND TEST 1
Step 1
Place a torch in cabinet, then close the door and check to see if light leaks out from gasket.
Step 2
Blow hot air onto gasket with hair dryer to soften, so that gasket can be easily attached onto cabinet.
DIAGNOSIS 1
PROCEDURE 1
Step 1
Remove screw cover.
Step 2
Unscrew.
Step 3
Remove the top cover.
Step 4
Unscrew bolts and screws.
Step 5
Remove the door.
DIAGNOSIS 2
Case 1:
Light leaks from the corner on opening side.
PROCEDURE 2
Step 1
Use bottom hinge with large hole and push outward.Step 2
Use upper hinge with large hole and push outward.
Step 3
Use hair dryer to blow hot air onto gasket on hinge side to soften so that gasket can easily attach onto cabinet.
Case 2:
Light leakage can be seen from the corner of door hinge side.
Step 1
Use bottom hinge with large hole and push inward.Step 2
Use hinge with large hole and push outward.
Step 3
Use hair dryer to blow hot air onto gasket on hinge side to soften so that gasket can easily attach onto cabinet.
DIAGNOSIS 3
Step 1
After adjusting hinges, put a torch into cabinet and check to see if any light leaks out through gasket.
Case 3:
Light leakage can be seen from the middle.
Step 1
Use steel ruler to measure the deformation of cabinet.
Step 2
Use steel ruler to measure the deformation of door.
DIAGNOSIS 4
PROCEDURE 3
Step 1
Remove screw cover.
Step 2
Unscrew.
Step 3
Remove the top cover.
Step 4
Unscrew bolts and screws.
Step 5
Remove the door.
PROCEDURE 4
Step 1
Use hair dryer to blow hot air onto gasket on hinge side to soften so that gasket can easily attach onto cabinet.
Tip 1
When installing door onto hinge, please check the alignment between door stopper and hinge.
Tip 2
Make sure gasket is properly attached.
Tip 3
Make sure the door is parallel to the cabinet.
GO BACK TO COMPONENT LIST