CHECK AND TEST 1

Step 1

Plug off the product.
If LED is off, the appliance is switched off. 

Step 1

Remove LED cover.

Step 2

Unscrew 

Step 4

Pull capillary from the hole.

Step 5

Lever off the knob. 

Step 6

Disconnect terminal for thermostat. 

Step 7

Remove thermostat 

Step 8

Test thermostat individually 

DIAGNOSIS 1

PROCEDURE 2


Tip 1:

When inserting capillary into the hole, make sure the first red mark goes in the hole, but second one remains outside of the hole. 

Tip 2:

Make sure pins of thermostat cover are properly inserted into the holes. 

Tip 3:

Make sure wires are pushed into cavity for thermostat. 

DIAGNOSIS 2

Step 1

Set the knob of thermostat to gear Max-1, and switch on the appliance to do a performance check.

Step 2

After 40min or 60 min, test the internal temp. 

GO BACK TO COMPONENT LIST