CHECK AND TEST 1
Step 1
Use steel ruler to measure the gap and misalignment.
Case 1
Upright gap is not even.
DIAGNOSIS 1
PROCEDURE 1
Step 1
Lever off the screw cover.Step 2
Unscrew.
Step 3
Remove the top cover.
Step 4
Unscrew 3 bolts.
Step 5
Remove the door.
Step 6
Remove adjustable foot.Step 7
Unscrew and remove bottom hinge.
PROCEDURE 2
Step 1
Move bottom hinge inward or outward.
Step 2
Move top hinge inward or outward.
PROCEDURE 3
Step 1
After installing the door, blow hot air onto gasket with Hair Dryer to soften, so that gasket can be easily attached onto cabinet.
Tip 1
If there is a washer on hinge, please don’t forget to add washer onto hinge pin.
Tip 2
When installing door onto hinge, please check the alignment of doorstopper and hinge.
Tip 3
Make sure gasket is properly attached.
Tip 4
Make sure gaps between doors are even.
DIAGNOSIS 2
Case 2
Door and side panel is misaligned.
DIAGNOSIS 1
PROCEDURE 1
Step 1
Lever off the screw cover.Step 2
Unscrew.
Step 3
Remove the top cover.
Step 4
Unscrew 3 bolts.
Step 5
Remove the door.
Step 6
Remove adjustable foot.Step 7
Unscrew and remove bottom hinge.
PROCEDURE 2
Step 1
Move bottom hinge toward left or right.
Step 2
Move top hinge toward left or right.
PROCEDURE 3
Step 1
After installing the door, blow hot air onto gasket with Hair Dryer to soften, so that gasket can be easily attached onto cabinet.
Tip 1
If there is a washer on hinge, please don’t forget to add washer onto hinge pin.
Tip 2
When installing door onto hinge, please check the alignment of door stopper and hinge.
Tip 3
Make sure gasket is properly attached.
Tip 4
Make sure gaps between doors are even.
DIAGNOSIS 2
Case 3
Horizontal gap between door and top cover is not even.
DIAGNOSIS 1
PROCEDURE 1
Step 1
Add or reduce washers to adjust misalignment in fore-and-aft direction.
DIAGNOSIS 2
CHECK AND TEST 2
Step 1
Check if hinge sleeve is worn.
DIAGNOSIS 3
PROCEDURE 1
Step 1
Lever off the screw cover.Step 2
Unscrew.
Step 3
Remove the top cover.
Step 4
Unscrew 3 bolts.
Step 5
Remove the door.
Step 6
Remove adjusted foot.Step 7
Unscrew and remove bottom hinge.
PROCEDURE 3
Tip 1
If there is a washer on hinge, please don’t forget to add washer onto hinge pin.
Tip 2
When installing door onto hinge, please check the alignment of door stopper and hinge.
Tip 3
Make sure gasket is properly attached.
Tip 4
Make sure gaps between doors are even.
DIAGNOSIS 4
