CHECK AND TEST 1
Step 1
Place a torch on shelf and point light towards gasket.
Step 2
Close freezer door to check if there is any light leaking out.
Step 3
Blow hot air to gasket by hair dryer to soften gasket so that gasket can be attached onto cabinet easily.
DIAGNOSIS 1
PROCEDURE 1
Step 1
Lay the appliance down
on a foam pad.
Step 2
Unscrew top hinge cover
with 8mm inner hexagon
driver and take the cover
out.
Step 3
Use screw driver to push
the buckle inward and
prize the PCB board out.
Step 4
Use screw driver to push
the buckle inward and
prize the wires out.
Step 5
Unscrew top hinge with
8mm inner hexagon driver.
Step 6
Unscrew adjustable feet.
Step 7
Unscrew.
Step 8
Take bottom hinge out.
Step 9
Remove the door.
PROCEDURE 2
Case 1:
Light leaks out from the corner of opening side.
Step 1
Use hinge with large hole
and push outwards.
Case 2:
corner of hinge side.
Step 2
Use hinge with large hole
and push inwards.
Case 3:
Light leaks out from the
middle of opening side or
hinge side.
Step 3
Use steel ruler to
measure the deformation
of fridge door.
If deformation is more
than 3mm, replace the
fridge door.
Step 4
Use steel ruler to
measure the deformation
of cabinet.
If deformation is more
than 3mm, replace the
appliance.
PROCEDURE 2
Tip 1
Make sure gasket is
attached well.
Note: 4 sides must be
checked.
CHECK AND TEST 2
Step 1
Place a torch on shelf and point light towards gasket.
Step 2
Close freezer door to see if there is any light leaking out.
DIAGNOSIS 2
GO BACK TO COMPONENT LIST