Step 1

Set the knob of thermostat
at gear Min, and switch on
the appliance. Study below
table to find thermostat
bulb position.

Step 5

According to model name
in rating label, study
diagram below to find
position of thermostat
bulb.

Step 4

Perform following 2 tests:
1. When compressor
stops for second
time, measure temp.
in the area near the
thermostat bulb.
2. When the compressor
starts again, measure
temp. in the area near
the thermostat bulb.

Step 2

Step 3

Remove thermostat
cover.

Step 4

Check to see if the first
red mark goes in the
hole, but second one
remains outside of the
hole.

Step 1

Pull capillary from the
hole.

Step 2

Tape capillary bulb onto
inner liner where bulb is
located in foam.

Step 3

Keep the gear at Min
and check whether
compressor stops or not.

Step 4

When compressor
stops, measure the
temperature.

Step 1

Insert capillary into the
hole.

Step 2

Connect all the terminals.

Step 3

Install thermostat cover.

Step 4

Screw and fix the
thermostat cover.

Step 5

Install the screw cover.

Tip 1:

When inserting capillary
into the hole, make sure
the first red mark goes
into the hole, but second
one remains outside of
the hole.

Tip 2:

Make sure the pins of
thermostat cover are
properly inserted into
the holes.

Tip 3:

Make sure wires are
placed into cavity of
thermostat.