CHECK AND TEST 1

Step 1
Open the door to let
internal temp. warm up
to ambient temp.. Then,
set gear to the coldest
setting and let appliance
run for 40 min.

Step 2

Turn knob slowly
towards lower settings
until the compressor
stops.

DIAGNOSIS 1

PROCEDURE 1


Step 1

Remove screw cover on
the LED.

Step 2

Unscrew LED cover.

Step 3

Remove thermostat
cover.

Step 4

Pull capillary from the
hole.

Step 5
Disconnect the terminals.

Step 6

Lever off the knob.

Step 7

Disconnect terminal for
thermostat.

CHECK AND TEST 2

Step 1

Test thermostat
individually when Gear is
set to 0.

DIAGNOSIS 2


PROCEDURE 2


Tip1:

When inserting capillary
into the hole, make sure
the first red mark goes
into the hole, but second
one remains outside of
the hole.

Tip 2:

Make sure the pins of
thermostat cover are
properly inserted into
the holes.

Tip 3:

Make sure wires are
placed into cavity of
thermostat.

CHECK AND TEST 3

Step 1

Set gear to the coldest
setting.

Step 2

Close the doors and let
appliance run for 40 min.

DIAGNOSIS 3


GO BACK TO COMPONENT LIST