PROCEDURE 1

Step 1

Plug off the product.
If LED is off, the
appliance is switched off.

Step 2

Remove LED cover.

Step 3

Unscrew screw cover.

Step 4

Remove thermostat
cover.

Step 5

Pull capillary from the
hole.

Step 6

Lever off the knob.

Step 7

Disconnect terminal for
thermostat.

CHECK AND TEST 1


Step 1

Test thermostat
individually when Gear is
not set to 0.

DIAGNOSIS 1

PROCEDURE 2


Tip 1
When inserting capillary
into the hole, make sure
the first red mark on
capillary goes into the
hole, but second mark
remains outside of the
hole.

Tip 2

Make sure pins of
thermostat cover are
properly inserted into the
holes.

Tip 3

Make sure wires are
pushed into cavity for
thermostat.

CHECK AND TEST 2


Step 1

Set the knob of
thermostat to gear
Max-1, and switch on
the appliance to do a
performance check.

Step 2

After 40min or 60 min, test
the internal temp.

DIAGNOSIS 2



GO BACK TO COMPONENT LIST