CHECK AND TEST 1
Step 1
Open fridge door to switch on LED LIGHT, if LED is off, proceed to LED FAULT to find out solution.
Step 2
Open freezer door to same degree with fridge door.
DIAGNOSIS 1
Step 1
Use 2mm slotted screwdriver to lever the cover off.
Step 2
Move the cover away from the buckle.
Step 3
Disconnect the terminal and take out the switch.
CHECK AND TEST 2
Step 1
Check to see if the terminal is connected well or not.
Step 2
Attach magnetic bar to magnetic switch.
Step 3
Use multimeter to test the resistance value.
Step 4
Take note of the value.
DIAGNOSIS 2
NOTE
Result 0 depends on measure range of multimeter. Recommended set measurement range is at least 2K ohms.
PROCEDURE 2
Step 1
Carefully place switch in trough to avoid damage.
Step 2
Insert the pin into buckle.
Step 3
Push the cover in.
DIAGNOSIS 3
CHECK AND TEST 3
Put a small bolt near edge of magnetic area. The magnetic force of the magnetic bar in
top of freezer door should move the bolt to center of door.
DIAGNOSIS 4
Note
PROCEDURE 3
Step 1
Unscrew hinge cover.
Step 2
Remove the cover.
Step 3
Disconnect the terminals.
Step 4
Unscrew 3 bolts and remove the top hinge.
Step 5
Remove fridge door.
Step 6
Loosen the middle hinge and remove it.
Step 7
Remove freezer door.
DIAGNOSIS 5
CHECK AND TEST 4
Step 1
Press button of switch to check if LED LIGHT is on or off.
DIAGNOSIS 6
PROCEDURE 4
Step 1
Insert slotted screw into edge of switch.
Step 2
Lever top edge of switch out.
Step 3
Lever switch out of buckle.
Step 4
Polish any scratches during disassembly and insert switch into the hole.
DIAGNOSIS 7
DIAGNOSIS 8
PROCEDURE 5
Tip 1
Don’t forget to add washer onto hinge pin.
Tip 2
When installing dooron the hinge, please check to ensure proper alignment of door-stopper and hinge.
Tip 3
Ensure gasket is attached properly.
Tip 4
Ensure gaps between doors are even.
GO BACK TO COMPONENT LIST