CHECK AND TEST 1
Step 1
Unscrew cover of mainboard with a Cross-head screwdriver.
Step 2
Test resistance of
potentiometer from
“Dor1” and “GND”.
Step 3
Turn the knob from 0 to
max to test resistance of
potentiometer.
PROCEDURE 1
Step 1
Remove shelves.
Step 2
Remove chill box.
Step 3
Remove chill flap.
Step 4
Lever 2 decorative strips
off and remove.
Step 5
Remove the 4 screws.
Step 6
Pull out fridge air duct.
Step 7
Disconnect the terminals.
Step 8
Lever clasp off.
Step 9
Disconnect the terminal.
CHECK AND TEST 2
Step 1
Check to see if terminals
are pushed into final
position.
If not, repeat.
Step 2
Check to see if terminal on fridge wall is filled with foam.
Step 3
If so, use tweezers to
remove the foam.
Step 4
Connect the 2 ends (“Dor1” and “GND”) of terminal for potentiometer.
Step 5
Check the connections of wires for potentiometer.
DIAGNOSIS 1
CHECK AND TEST 3
Step 1
Measure resistance of
potentiometer on each
gear.
DIAGNOSIS 2
PROCEDURE 3
Tip 1
When reinstalling fridge air duct, first put the positive end of buckle on the top into the negative ends.
Tip 2
Then put the positive end of buckle on the sides into the negative ends.
Tip 3
Lastly, fasten the buckles on the sides by knocking them in.
DIAGNOSIS 1
GO BACK TO COMPONENT LIST