PROCEDURE 1

Note

Led terminals are covered by Led light cover, you need to disassemble and remove cover to check. 

Step 1

Lever the LED cover off with 2mm slotted driver. 

Step 2

Unscrew with 6mm Cross-head screwdriver. 

Step 3

Disconnect the terminal and remove LED. 

Step 4

Put wires into buckle to avoid damaging with screw. 

CHECK AND TEST 1

Step 1

Provide upper LED with DC12V to check whether it turns on or not. 

DIAGNOSIS 1


CHECK AND TEST 2

Step 1

Check to make sure wire order is correct. 

Step 2

Check with multimeter to make sure there is a good connection. 

DIAGNOSIS 2


CHECK AND TEST 3

Step 1

Check if terminal is filled with foam 

Step 2

In the same way, check connection, wire order and terminals of LED in fridge compartment. 

DIAGNOSIS 3


PROCEDURE 2


Step 1

Cut off the wire. 

Step 2

Peel off the sleeves. 

Step 3

Make sure wires are in proper order and connect them. 

Step 4

Tin soldering. 

Step 5

Cover connecting point with electrical tape. 

GO BACK TO COMPONENT LIST