CHECK AND TEST 1

Step 1

Plug off the product and
open the door to let
internal temp., warm up
to ambient temperature.

Step 2

Set thermostat to max-1,
and plug in to switch on
the appliance.


DIAGNOSIS 1


CHECK AND TEST 2

Step 1

After first stop, please
consult table 1 to find bulb
position, then measure
temperature in the area
near thermostat bulb.

DIAGNOSIS 2



PROCEDURE 1


Step 1

Lever off screw cover.


Step 2
Unscrew.

Step 3

Remove thermostat
cover

Step 4
Pull capillary from the
hole

Step 5

Disconnect terminal for
LED.


Step 6

Disconnect terminal for
thermostat.

Step 7

Lever off the knob

Step 8
Unscrew the nut.

Step 7

Remove the thermostat.

PROCEDURE 2


Tip 1:

When inserting capillary
into the hole, make sure
the first red mark goes in
the hole, but second one
remains outside of the
hole.

Tip 2:

Make sure the pins of
thermostat cover are
inserted into the holes.


Tip 3:
Make sure wires are
placed into cavity of
thermostat.

CHECK AND TEST 3


Step 1

After first stop, please
consult table 1 to find bulb
position, then measure
temperature in the area near
thermostat bulb.

Step 2
Set the knob of thermostat
at gear max-1, and plug in
to switch on the appliance.

DIAGNOSIS 3

DIAGNOSIS 4



GO BACK TO COMPONENT LIST