Note
DIAGNOSIS 1
CHECK AND TEST 1
Step 1
Set the knob of thermostatat gear Min, and switch on
the appliance.
Step 2
Study table 1 to find
thermostat bulb position.
Step 3
Perform following 2 tests:1 When compressor
stops for second time,
measure temp in the
area near thermostat
bulb.
2 When compressor
starts again, measure
temp in the area near
thermostat bulb.
DIAGNOSIS 2
PROCEDURE 1
Step 1
Lever off the screw
cover.
Step 2
Unscrew screw cover. Step 3
Remove thermostat
cover.
CHECK AND TEST 2
Step 1
Check to see if the first
red mark goes in the
hole, but second one
remains outside of the
hole.
CHECK AND TEST 3
Step 1
Set the knob of thermostat
at gear Min, and switch on
the appliance.
Step 2
Study table 1 to find
thermostat bulb position.
Step 3
Perform following 2 tests:1 When compressor
stops for second time,
measure temp in the
area near thermostat
bulb.
2 When compressor
starts again, measure
temp in the area near
thermostat bulb.
DIAGNOSIS 3
CHECK AND TEST 4
Step 1
Lever off the screw
cover.
Step 4
Pull capillary from thehole.
Step 5
Tape capillary bulb onto
inner liner where bulb is
located in foam.
Step 6
Keep the gear at Minand check whether
compressor stops or not.
Step 7
When compressor
stops, measure the
temperature.
DIAGNOSIS 3
PROCEDURE 2
Step 1
Insert capillary bulb into
the hole.
Step 2
Put all the wires intothe cavity of thermostat
cover.
Step 3
Screw to fix thethermostat cover and
install the screw cover.
Tip: 1
When inserting capillaryinto the hole, make sure
the first red mark goes
into the hole, but second
one remains outside of
the hole.
Tip: 2
Make sure the pins ofthermostat cover are
properly inserted into
the holes.
Tip: 3
Make sure wires areplaced into cavity of
thermostat.
GO BACK TO COMPONENT LIST