PROCEDURE 1


Step 1

Unscrew bottom
attachment.

Step 2

Unscrew top
attachment.

Step 3

Remove the plastic
guider cover.

Step 4

Unscrew the plastic
guider.

Step 6

Hold cabinet and pull
appliance out.


Note:
Reverse procedures
above to install the
appliance.

NOTE

CHECK AND TEST 1


Step 1

Discharge refrigerant: cut off the charging tube with pliers.

Step 2

Discharge all refrigerant toward the exhaust vent.

Step 3

Melt brazing material with flame and pull out processing tube using a pair of pliers.

Step 4

Re-braze a copper tube onto compressor processing tube. Click below link to get more details for brazing requirements, go to Annex B1

NOTE

Step 5

Install quick connector onto re-brazed pipe.

Step 6

Cut off suction pipe and exhaust pipe.

Step 7

Power up the compressor and feel the exhaust pressure from the exhaust pipe with a piece of paper.


Step 8
Feel the suction pressure
of the suction pipe using
a piece of paper.

DIAGNOSIS 1

PROCEDURE 2

Step 1

Unscrew terminal cover.

Step 2

Remove terminal cover.

Step 3

Remove protector and
starter.

Step 4
Unscrew earthing wire.

Step 5

Unscrew nut of compressor.

Step 6

Install a new compressor and tighten nuts onto compressor.

Step 7

Braze the joints of suction and exhasuting pipes.

PROCEDURE 3


Step 1

Clean paint off brazed
joint of drying-filter.

Step 2
Cut off drying-filter.

Step 3
Cut off capillary and
shake to remove the
cut end.

Step 4
Braze on a new
drying-filter.

Step 5
Inject nitrogen
(1.57Mpa) through
quick connector
into pipe for at least
3 min to blow
remaining refrigerant
away.

Step 6
Add quick connector
onto processing pipe
of drying-filter.

Step 7
Perform leakage test on
brazed joints of dryingfilter
and compressor
processing pipe.

Step 8
Vacuum and recharge. Click below link to get more details for vocuuming and gas-charging requirements, go to Annex B2

Step 9
Block processing pipe twice by locking pliers.


Step 10
Leave locking pliers on
the second blocking and
cut off the rest pipe by
shaking.

Step 11
Braze the ends and
remove the pliers.

DIAGNOSIS 2

GO BACK TO COMPONENT LISTÂ